Following on from the post a couple of weeks ago I have made up an expression to help me label just the centreline levels on my sections. I have to make use of expressions again to minimize the labels you do not want to see by reducing there height.
as follows
to make them disappear I used the following expression for the text and block height if the offset is zero it makes the objects 2.5mm high otherwise make them 0.01mm high.
Justin, unchecking the start/end offset boxes does not stop them from being labeled (as you've found). They merely allow you to change the range that IS labeled, so change these values to fall where no grade breaks occur, such as -0.1 & 0.1.
ReplyDeleteJeff
ReplyDeleteI was not sure what you were meaning at first so tried it and see now. If you just want to label the centre like I was then setting the offset range to start at -0.1m and end at 0.1m stops labels appearing outside of this range.
Justin