A question from one of our team today was
“I have put the subgrade surface in all the profiles. It doesn’t seem to be providing points for all the chainages though, for example at CH0, 40 & 50 in the attached picture.”
This is usually because the profile in the profile 1 column for the bands is different as this is the profile Civil3d determines the spacing of the label points form unless the match vertical grid spacing is ticked. Check that the settings are correct for the bands as highlighted below.
Note : Sometimes additional tick and labels appear in the band only at horizontal and Vertical Geometry points this is because these are turned on in the Band style under the display tab.
No comments:
Post a Comment