Well I have download Civil3d 2012 and loaded it and looked into this new pipe rule and the verdict for me is not good.Sure it stops the pipe short in plan view and has the grips there but the grips are not at the edge of the structure in ProfileView as I hoped.
Also the alignment from network parts command does not work correctly now and the alignment places the IP not at the centre of the structure but jumps to the end of the next pipe this error is most likely dependant on the angle of deflection between the incoming and out going pipes.
Also the alignment from network parts command does not work correctly now and the alignment places the IP not at the centre of the structure but jumps to the end of the next pipe this error is most likely dependant on the angle of deflection between the incoming and out going pipes.
Peter Thomson’s comments on the subject
No comments:
Post a Comment